How to maintain the mill in spring

search for: in: entire forum this post
you are here: root => General Discussion => How to maintain the mill in spring
member since:
folders:
1
posts:
190
replies:
0

How to maintain the mill in spring


Through the cold and humid winter, sunny, spring season has finally arrived, not only many birds have flown on the sky began to fly freely, even hibernation for a long time the ultrafine mill also come out activities, then in such a season In the mill how to use and maintain it?
The use and maintenance of the mill We can be divided into three aspects, the first is to regularly check the gear pair, bearings and other working conditions; followed by the regular inspection of the roller wear and clean up the foreign body; Finally, but also to do the gear Lubrication work.
In detail, the mill is in the process of operation, if there is an abnormal sound, the machine does not rotate smoothly, the bearing temperature increases, abnormal, you need to promptly check the problem and promptly resolved. When the top of the pinion in the ultrafine mill and the gap between the root of the ring gear and the ring gear of the ring gear become larger, it is necessary to stop and readjust the center distance of the gear pair; when the tooth surface of the pinion along the rotation direction is worn seriously, And for the surface, so that the other side of the component becomes the main force surface. When the gear broken tooth situation, we must promptly replace the new gear.
When the bearing shaft clearance becomes larger, to repair the pinion shaft. When the pinion radial clearance becomes larger, to install copper to reduce the gap; when the axial clearance and radial clearance can not be adjusted, or roller pitting, rotation is not flexible, etc., need to be replaced.
In addition, the mill lubrication work is a big aspect, in the operation of the mill, the lubrication is mainly for the machine bearings, all kinds of gears. At present, the degree of automation of the mill lubrication has been increased, reducing the intensity of manual operation, but need to emphasize that geese are, users often need to lubricate the mill.
post #194
permalink
member since:
folders:
0
posts:
0
replies:
164
post #871
permalink

moderators of this post

18137782032 (level: ∞)
powered by Nodesforum